EPSON Stylus Pro 9000 Revision B
Disassembly & Assembly Disassembly Flow 86
6. Remove two screws (CB M3x6), and remove the carriage cover.
Figure 4-20. Carriage Cover Removal *with H Top removed
7. Remove one screw (CP(W2) M3x6) securing the damper holder and the
ground, unhook the ink tubes from the damper holder, and then remove
the damper holder.
8. Pull out the dampers. To pull out the dampers, place the tip of a flat-head
screwdriver or similar tool under the damper and steady the damper with
your other hand. Then pull out the damper.
Figure 4-21. Damper Removal
CB M3x6 screws
CAUTION
Do not squeeze the dampers and try to only touch the
edges of the dampers. If pressure is applied to the middle of
the dampers, the ink inside will squirt out.
Insert a flat-head screwdriver between the bottom of the
damper and the printhead to remove the damper.
To Next Page
Loading...
