Epson Stylus Pro 9000 - Page 99

EPSON Stylus Pro 9000 Revision B
Disassembly & Assembly Disassembly Flow 99
5. Loosen two screws securing the fixintg plate that holding the ink tubes and
a FFC inside the I/H assembly. And unhook two tabs and remove the hand
hold cover.
6. Remove the two screws (CP(W2) M3x6) securing the ink tube holder plate,
and disconnect the FFC from the connector CN1 on the I/H relay board
attached at the bottom of the I/H assembly.
Figure 4-44. Removing the fixing plate
Figure 4-45. Removing te FFC
CHECK
PO INT
To remove two screws securing the ink tube holder plate,
you need a short-neck screwdriver.
Push to release
the tabs