Epson TM-C3500 Series - Cut Position Adjustment

Chapter 3 Handling
131
3
Cut Position Adjustment
The paper feed pitch is adjusted as described below depending on the [Media detection settings].
Media detec-
tion settings
Description
Die-cut label
(Gap)
Transparent die-
cut label
 Specifying a positive value moves the cut position closer to the reference
position (print start position).
 Specifying a negative value moves the cut position away from the reference
position (print start position).
Die-cut label
(Blackmark)
 Specifying a positive value moves the cut position closer to the reference
position (print start position).
 Specifying a negative value moves the cut position away from the reference
position (print start position).
≎
≐
Backing paper
Label
Label
Print result
Print reference
(Print start position)
Cut position
≎
≐
Backing paper
Label
Label
Print result
Print reference
(Print start position)
Cut position