Epson TM-C3500 Series - Fanfold Paper

168
•Die-cut label (Blackmark), die-cut label (gap), and transparent die-cut label
Place the edge of the first label in a position 172.5 mm {6.791”} or more from the edge of the
roll paper, and do not place a label or black mark before there, leaving only the backing.
Fanfold Paper
The following media is supported:
•Continuous paper (Blackmark)
•Die-cut label (Blackmark)
Method for arranging the media
•Continuous paper (Blackmark)
Place the edge of the first black mark in a position 25 mm {0.98”} or more from the edge of the
paper, and do not place a black mark before there.
•Die-cut label (Blackmark)
Place the edge of the first label in a position 25 mm {0.98”} or more from the edge of the paper,
and do not place a label or black mark before there, leaving only the backing.
Paper feed
direction
Label edge
172.5 mm {6.791” } or more
Paper feed
direction
Black mark position
25 mm {0.98” } or more
Paper feed
direction
Black mark position
25 mm {0.98” } or more