Chapter 5 Maintenance
199
5
Network Printer
Configure the IP address and other network settings of the existing printer and the settings of the
existing printer in the new printer. There is no need to configure the printer driver on the client
computer.
❏ Preparation
•The network setting information of the existing pr
inter (IP address and so on)
Print the st atus sheet with the existin g printer. (See "Status Sheet Printing (LAN interface
model only)" on page 162)
•Backup file of the existing printer
❏ Printer replacement procedure
1. Start Deployment Tool on the administrator's computer and set the IP address, Media
source settings, and Media detection settings to the new printer.
2. Install the new printer in the location where the existing printer was installed and
connect it to the network.
3. Set the media and ink cartridge in the new printer and charge ink.
4. From EPSON Monitoring Tool on the administrator's computer, set up the printer using
the backup file.
To Next Page
Loading...
Need help?
General