Chapter 1 Product Overview
17
1
CUT button
❏ If "Media detection settings" is set to "Full-page label/Continuous paper/Transparent full-
page label", feeds the paper to the autocutting position for the top of the next page, and
performs autocutting.
❏ If "Media detection settings" is set to "Die-cut label (Blackmark)", "Continuous paper
(Blackmark)", or "Die-cut label (Gap)/Transparent die-cut label", feeds the paper to the
autocutting position
according to the black mark or the gap between labels, and performs
autocutting.
Cleaning button
If the cleaning button is held down for approximately 3 seconds, head cleaning is performed.
The following settings are possible from the driver regarding cleaning operations when the
cleaning button is held down.
STATUS SHEET button
Press the status sheet button to print the status sheet.
If you turn on the power while holding the status sheet button, and continue to hold it for 10
seconds or more, you can return the LAN interface settings to factory default settings.
However, in order to prevent errors due to pieces of paper, even if you press the cut but-
ton again, cutting is not performed in a position where cutting was already performed.
Approximately 2 seconds is required from the point when the CUT button is pressed
until the point when paper cut starts.
No. During stand-by During printing
1 Disabled Disabled
2 Head cleaning performed Disabled
3 Head cleaning performed
Printing canceled -> head cleaning performed ->
printing resumed
To Next Page
Loading...
Need help?
General
