120
Paper Loading Settings
Follow the steps below to specify the settings for paper loading at power-on/paper cover close.
The following types are available for the settings for paper loading at power-on/paper cover
close. (The type is set to [Paper feed for positioning (With cutting)] by default. If you use the
default setting, there is no need to change the settings.)
Paper loading at power-on
Settings Description
Paper feed for
positioning (With
cutting)
Paper loading settings: Die-cut label (Blackmark), Continuous paper (Black-
mark), Die-cut label (Gap)/Transparent die-cut label
Paper is loaded based on the upper end of black mark/label detected by the
black mark detector or label detector. After paper feed is finished, autocut is
performed and the printer enters the standby status.
Paper loading settings: Full-page label/Continuous paper/Transparent full-
page label
A certain amount of paper is fed. After paper feed is finished, autocut is per-
formed and the printer enters the standby status.
Paper feed for
positioning
(Without cutting)
Paper loading settings: Die-cut label (Blackmark), Continuous paper (Black-
mark), Die-cut label (Gap)/Transparent die-cut label
Paper is loaded based on the upper end of black mark/label detected by the
black mark detector or label detector. After paper feed is finished, no autocut
is performed and the printer enters the standby status.
Paper loading settings: Full-page label/Continuous paper/Transparent full-
page label
A certain amount of paper is fed. After paper feed is finished, no autocut is per-
formed and the printer enters the standby status.
No paper feed
for positioning
No paper loading or paper feeding is performed.
To Next Page
Loading...
