Epson TM-C3500 Series - Network Interface; Factory Settings; How to Initialize the Settings to the Factory Settings

138
Network Interface
The LAN interface information for this printer is as shown below.
Factory settings
The factory settings for this printer are as follows:
How to initialize the settings to the factory settings
Follow the steps below to initialize the LAN interface of this printer.
1
Make sure that the printer is turned off.
2
Turn the power on while pressing the STATUS SHEET button; then continue
to press the status sheet button for ten seconds or more. The settings for
the LAN interface can be changed to the factory settings.
Item Factory settings
IP address setting mode: Manual
IP address: 192.168.192.168
Host computer name: EPSONxxxxxx
(xxxxxx sets the lowest 6 digits of the MAC address.)
Domain name None