186
Setting the Printer
You can set the following items before charging ink in the printer:
•Media source settings
•Media detection settings
•Network settings such as IP address
You can set the media settings and IP address settings which are minimally necessary to use a printer
before ink charging. This reduces operations at the installation
location, contributing to reduction in
required time and efficiency improvement for installation operation.
You can also avoid troubles caused by moving the printer after ink charging.
Setup after ink charging
Set the items listed below after ink charging. For details on the settings after ink charging, see
"Changing the Printer Settings" on page 191.
•Printer operation settings
•Notification settings
•Panel button settings
•Operating time settings
• Paper feed adjustment
Printer Setting procedure
Local Printer Using TM-C3500 Printer Driver on each client computer
Network Printer Using EPSON Monitoring Tool
Other settings on the administrator's computer/client computer
Have the following printer setting list beforehand:
•Media source settings
•Media detection settings
•Network settings
Charge ink (Approx. 10 minutes)
Complete
<Installation Location>
<Administrator's Computer>
To Next Page
Loading...
Need help?
General