74
22
Insert the fanfold paper into the paper slot, facing the print surface
upward. Insert the paper until it is pulled into inside the printer (approxi-
mately 100 mm {3.94"}). The printer detects the edge of the fanfold
paper, pulls it inside, and then starts feeding it to the print starting posi-
tion.
23
Place the stack of fanfold paper straight at least 40 mm {1.57"} away
from the back of the printer.
When "Paper loading at roll paper cover close" is set to "With cutting", the paper is auto-
matically cut after fed. (See "Paper Loading Settings" on page 120.)
To Next Page
Loading...
