Epson XP-970 Series - Changing the Connection Method to the Computer

❏ Setting up from the website
Access the following website, and then enter the product name. Go to Setup, and then start setting up.
http://epson.sn
❏ Setting up using the soware disc (only for the models that come with a soware disc and users with Windows
computers with disc drives.)
Insert the soware disc into the computer, and then follow the on-screen instructions.
Follow the on-screen instructions.
Changing the Connection Method to the Computer
is
section explains how to change the connection method when the computer and the printer have been
connected.
Changing the Network Connection from Ethernet to Wi-Fi
Change the Ethernet connection to Wi-Fi connection from the printer's control panel.
e
changing connection
method is basically the same as the Wi-Fi connection settings.
Related Information
& “Making Wi-Fi Settings from the Control Panel” on page 264
Changing the Network Connection from Wi-Fi to Ethernet
Follow the steps below to change from a Wi-Fi connection to an Ethernet connection.
1.
Tap Settings on the home screen.
2.
Tap Network Settings > Wired LAN Setup.
3.
Tap Start Setup.
4.
Check the message, and then tap OK.
5.
Connect the printer to the router with an Ethernet cable.
Changing from USB to a Network Connection
Using the installer and re-set up in a dierent connection method.
❏ Setting up from the website
Access the following website, and then enter the product name. Go to Setup, and then start setting up.
http://epson.sn
❏ Setting up using the
soware
disc (only for the models that come with a
soware
disc and users with Windows
computers with disc drives.)
Insert the soware disc into the computer, and then follow the on-screen instructions.
Adding or Replacing the Computer or Devices > Re-setting the Network Connection > Changing t …
262