EasyManua.ls Logo

Equipment Technologies APACHE AS1010 - Page 113

Default Icon
124 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
TROUBLESHOOTING
8-3
Apache Sprayer will not spray. Confirm engine is running.
Confirm product in product tank.
Confirm ball valves from tank to product pump
are open.
Confirm product pump is turned on.
Check ground speed on Raven display.
Confirm boom valves are opening.
Booms will not turn off. Check boom valves for operation.
Check electrical connections at boom valves.
Check electrical connections in cab.
Seat will not raise or lower. Check wire connections at right side of seat.
Raven monitor does not turn on. Check fuse in back of console.
Front suspension cylinder is flat. Lift tire off ground and check accumulator fluid.
If fluid is foaming, the accumulator has failed. If
fluid is low, fill to top of plug. Check operation.
Contact your dealer.
Rear suspension will not rise. Check hydraulic fluid level.
Check electrical connections at suspension
block and switches.
Product pump will not turn on. Confirm product pump switch in “ON” position.
Check electrical connections at hydraulic valve
block.
Check electrical connections in cab.
A/C does not cool. Confirm A/C switch in “ON” position.
Confirm fan in “ON” position.
Check belt to compressor.
Contact your dealer.
SYMPTOM SOLUTION

Table of Contents