LUBRICATION AND MAINTENANCE
5-9
If the oil level is below the “ADD” mark, add
high quality Lucas 15W-40 Magnum motor oil
at the oil fill location on the left side of the
engine.
Add oil as needed to bring the level to the
hatched area on the dipstick.
Replace the dipstick.
Additional lubricating oil system information is
available in the engine manufacturer’s man-
ual provided with the Apache Sprayer.
Check Cooling System
DO NOT remove the radiator cap when the engine is
hot. Stop the engine and wait until the engine has
cooled.
Remove the radiator cap. The coolant level should be
level with the bottom of the fill neck.
Add coolant as necessary. See the engine manufac-
turer’s manual for coolant requirement and additional
cooling system information.
Inspect the cooling package components for damage and
debris. Check tubes, hoses, and other components for
damage and leaks. Replace damaged components as
necessary. Clean debris from around or between cooling
package components.
Check Brake Fluid Level
The brake fluid reservoir is located in the engine compart-
ment, on the right side of the engine, toward the cab.
NOTE: Check the brake fluid level while the fluid is cold.
The reservoir is marked with “FILL” and “LOW” level indi-
cators. Maintain the fluid level between these two marks.
If the brake fluid level drops to the “LOW” level, remove
the reservoir cap and add Lucas Universal Hydraulic Fluid
to raise the fluid level to the “FILL” mark. Replace the cap.
NOTE: To reduce the possibility of air entering the brake
lines, do not allow the fluid level to drop below the “LOW”
level.
To Next Page
Loading...