WET SYSTEM OPERATION
4-26
Flushing Wet System
(without optional Roto-Flush)
CAUTION: Spray contaminated rinse water in
a safe location in accordance to chemical
label recommendations and local laws.
Follow chemical labels for proper rinsing pro-
cedure. Some chemicals may require multi-
ple tank flushings
NOTE: Read and follow chemical labels for
flushing, disposal, and protective clothing
requirement instructions.
IMPORTANT: DO NOT run the product
pump dry. Damage to the pump seals will
result. DO NOT intentionally dead-head
the pump with high pressures. Damage to
the pump seals will result.
Fill the rinse tank with clean, fresh, water.
See “Filling Rinse Tank” on page 4-11
Close the product valve (1) and open the
rinse tank valve (2).
Start the engine. Decrease the agitation to off
using the switch on the side console.
Unfold the booms and boom tips and lower
the boom rack as far as possible.
NOTE: If the Apache Sprayer is equipped
with an optional chemical eductor, flush the
eductor at the same time as the booms.
To Next Page
Loading...