WET SYSTEM OPERATION
4-27
Set the Raven Sprayer Control master switch
(1) to the “OFF” position.
Set the product pump switch (2) to the “ON”
position.
Set all the boom section switches (3) to the
“ON” position.
Press the master spray button on the T-han-
dle to begin spraying.
IMPORTANT: DO NOT run the product
pump dry. Damage to the pump seals will
result. DO NOT intentionally dead-head
the pump with high pressures. Damage to
the pump seals will result.
After the booms are flushed, set the boom
switches to “OFF”, return the T-handle to the
“IDLE” position, set the product switch to
“OFF”, fold the booms, and return all valves
to spraying positions.
To Next Page
Loading...