Essemtec Fox - Gaining Prerequisits C

Preventive Maintenance
4-66 © Essemtec AG Fox Maintenance
0000074/05
/ March 31, 2017
4.9.3 Gaining Prerequisits c
Stopping Production
Any Tab
Any Menu
Any Submenu
(STOP button)
Unloading Production Material
In case of equipment with conveyor, remove PCB(s) on conveyor input stage.
Produce
Production
Unload PCB
Remove PCB(s) on conveyor output stage.
In case of equipment without conveyor, unload all the PCBs manually.
Remove valves
Not relevant for Fox machine without dispensing.
It is absolutely mandatory to switch off the Jet-Controller before disconnecting the valve
cables. Failure to follow this chronological sequence may result in damaged controller or
valves.