Essemtec Fox - Page 7

Fox Maintenance © Essemtec AG vii
0000074/05
/ March 31, 2017
About this Manual
History
Index
Release
Changes
01
September 15,
2016
First release
02
January 06,
2017
Procedure to rinse the vacuum passage extended in chapter 'Head
Maintaining' of Yearly Maintenance c (spindle tip cleaning by means of
the conical brush).
03
February 01,
2017
Procedure for Conveyor Clamping Checking / Lubricating added to
chapter 'Monthly Maintenance a'.
Corrective Maintenance, chapter 'P&P Head', description if head removal is
required or not, has been improved.
Sub-chapter 'Head Removal from Machine', moved to the end of chapter
'P&P Head' to avoid any misunderstandings.
04
February 10,
2017
Corrective Maintenance, chapter 'Malfunction Table', has been improved.
05
March 31,
2017
Part number of grease added at all positions where P&P Head Grease is
used.
Procedure to rinse vacuum passage reworked.
Loctite 7063 replaced by IPA Isopropyl alcohol.
Purpose
This Maintenance Manual contains essential information (where applicable) concerning:
• the safe and efficient performance of preventive maintenance tasks on the Fox
• the safe and efficient performance of corrective maintenance tasks on the Fox
• the safe and efficient configuration and calibration of the Fox
• the schematics (electrical, electronic and pneumatic) of the Fox
• the tool kits used for calibration etc.
The knowledge of and adherence to the safety regulations and the compliance with additional
warning instructions described in this Maintenance Manual is a basic precondition for a safe and
error free work with or at the Fox.
This document (Maintenance Manual) and especially the safety regulations have to be observed by
all persons who work with or at the Fox. Additionally, all local safety and environmental regulations
have to be observed.