DIR911T User Guide
31
Eventide
Model DIR911t
Multi-Line Install Recall Recorder
Version: 1.8.0[3]
Figure 4: Boot Screen
8. After the unit boots and runs its internal startup tests, it will display the main
screen. This is shown in Figure #5.
16-May-68 04:31:12 Call# -------
Ready <No Call>
Len --:--:--
LIVE PREV CALL NEXT CALL RESTORE
Figure 5: Main Screen
9. At this point you are ready to set the configuration settings to tailor the unit to
your environment.
Powering Down the Unit
Units should not be powered off without first halting the system. Failure to heed this
warning may result in lost configurations and/or call database corruption. To halt the
system enter the setup mode and select the “Reboot/Halt System” configuration
screen. Press the halt button. After a brief period of time, the system will be halted
and will quickly blink the JOG/SHUTTLE, SPEED, and FILTER LEDs indicating so.
To Next Page
Loading...
