DIR911T User Guide
54
Method Description
INT Date/Time information is recovered from the internal hardware clock.
NTP Date/Time information is received from the designated NTP server.
NMEA Date/Time information is recovered from the Time port on the rear
panel using the NMEA format.
NENA 0 Date/Time information is recovered from the Time port on the rear
panel using the NENA 0 format.
NENA 1 Date/Time information is recovered from the Time port on the rear
panel using the NENA 1 format.
NENA 2 Date/Time information is recovered from the Time port on the rear
panel using the NENA 2 format.
NENA NIS Date/Time information is recovered from the Time port on the rear
panel using the NENA 3 format.
NENA GORGY Date/Time information is recovered from the Time port on the rear
panel using the NENA 4 format.
Table 7: Clock Synchronization Methods
Use the CURSOR soft key to locate the parameter to be changed. Use the encoder to
change the parameter. Once all the parameters are set press the SET soft key to effect the
changes. Press the DONE soft key to exit the menu.
Ethernet Setup
The Ethernet LAN setup screen is shown in Figure #37.
To Next Page
Loading...
