Eventide DIR911t - Caller ID Digits Filter; Figure 57: DTMF Digits Filter Screen; Figure 58: Caller ID Digits Filter Screen

DIR911T User Guide
67
Include calls whose DTMF digits
begin with:
CURSOR DEFAULT DONE
Figure 57: DTMF Digits Filter Screen
Use the CURSOR soft key to select the desired parameter to change. The first field has
possible values of “begin with”, “contain” and “end with”. The second field contains the
digits that the call must either begin with, contain, or end with in order to be considered.
The KNOB is used to change the value of the currently selected field. The DEFAULT
key will return the screen to the default value. Press the DONE key to exit back to the
call filter setup screen.
Caller ID Digits Filter
The Caller ID digits filter screen is used to constrain the search to include only calls that
were received that start with, contain, or end with a specified series of Caller ID digits.
The screen is shown in Figure #58
Include calls whose Caller ID digits
begin with:
CURSOR DEFAULT DONE
Figure 58: Caller ID Digits Filter Screen
Use the CURSOR soft key to select the desired parameter to change. The first field has
possible values of “begin with”, “contain” and “end with”. The second field contains the
digits that the call must either begin with, contain, or end with in order to be considered.
The KNOB is used to change the value of the currently selected field. The DEFAULT
key will return the screen to the default value. Press the DONE key to exit back to the
call filter setup screen.