Eventide DIR911t - Emailing Messages from Recall Mode; System Mode; Figure 8: Recall Email Screen; Figure 9: System Screen

DIR911T User Guide
36
The KNOB may also be used to maneuver around the call. Pressing the KNOB will
pause the call. While paused, turning the KNOB will rewind and fast forward through
the call. Press the KNOB again to continue playing.
Emailing Messages from Recall Mode
Pressing the EMAIL soft key while in Recall mode presents the following screen:
EMAILING Line # N Msg # M
To:<<call email address>>
SEND DONE
Figure 8: Recall Email Screen
Press the SEND soft key to email the currently selected message (identified by line #N
and message number #N as shown above) to the call recipient (this address is set up in
the system configuration menus).
Press the DONE key to exit this menu.
System Mode
System mode is where the unit is configured and monitored. The system mode screen is
shown in Figure #52.
Version: 1.7.0B[9]
Memory: 45.64/224.21MB Lines: 2
Remaining recording time: 02:16:02
CONFIG INFO ALERTS DONE
Figure 9: System Screen
The display shows the basic information on the system, as well as the amount of time
remaining for recording (free space plus non-saved calls).
NOTE: The remaining recording time is based on recording using the current sample
rate and compression setting.
Press the CONFIG soft key to go into the system configuration menu. Press the INFO
soft key to enter the information page. And if present, press the ALERT soft key to enter
into the system alert page (this would be present only if there are alerts pending).