DIR911T User Guide
40
Set Autorestore Time
The autorestore timer is used to return the unit to the main mode if it is left unattended for
the specified amount of time. This doesn’t include any of the system configuration
menus. The screen is shown in Figure #16.
Autorestore Time: 25.00sec.
DONE
Figure 16: Autorestore Screen
Use the encoder to adjust the autorestore time. Press the DONE key to exit the menu.
Line Auto Jump Setup
The Line Auto Jump feature allows the DIR911t to switch to the line with the most recent
call that is being recorded. The screen is shown in Figure #17.
Auto jump to newest call: DISABLED
DONE
Figure 17: Line Auto Jump Setup Screen
Use the encoder to enable or disable auto jump. Press the DONE key to exit the menu.
High Traffic Mode Setup
The DIR911t operates in one of two traffic modes: HEAVY and LIGHT. When in
HEAVY traffic mode, pressing the RECALL button after a call has started playing back
will jump to the start of the previous call. When in LIGHT traffic mode, pressing the
RECALL button after a call has started playing back will jump to the start of the
currently playing call. The screen is shown in Figure #18.
To Next Page
Loading...
