DIR911T User Guide
52
Centralized Archive Pointer Setup
The centralized archive pointer setup screen is shown in Figure #34.
Centralized Archiving Pointer:
01-Jan-89 00:00:00 GMT
CURSOR DONE
Figure 34: Centralized Archive Pointer Setup Screen
This screen provides a way to set the centralized archive pointer. The centralized archive
pointer is a point in time that is used to determine which calls are to be archived. When a
call is archived, the pointer advances to the start time of that call and the next unarchived
call is scheduled for centralized archiving. Changing the centralized archive pointer will
cause all calls that happen on or after that time to be centralize archived, even if they had
been previously centralized archived. Press the CURSOR to move between the various
fields of the date and time. Turn the encoder to the desired value. Press the DONE soft
key to update the pointer and exit this menu.
NOTE: updating the archive pointer may take some time depending on the DIR911t
model number and the number of calls currently stored.
Centralized Archive Status
The centralized archive status screen is shown in Figure #35.
Centralized Archive Status: DISCONNECTED
Archive Pointer:01-Jan-89 00:00:00 GMT
Unarchived: 1 Current: 0.00%
CURSOR DONE
Figure 35: Centralized Archive Status Screen
This screen shows the status of the Centrailzed Archiving task. This includes the state of
the task, the current archive pointer, the number of unarchived calls, and the percentage
complete of the current call being archived. The RESTART soft key is used to force a
To Next Page
Loading...
