DIR911T User Guide
50
WARNING-LINE
201-641-1200 MM:SS MM/DD/YY
CITIZEN’S NAME
STRNUM TRL PRE STREET NAME
STREET NAME CONT D SUFX DIR
MAP COORDINATE
COMMUNITY ST
BUILDING ID
UNIT FLR CLAS
PILOT # NPA-NXX-XXXX ESN
PSAP IDENTITY
LAW NPA-XXX-XXXX
FIRE NPA-XXX-XXXX
EMS NPA-XXX-XXXX
CF # NPA-XXX-XXXX LEC
If the ALI data received by the DIR911t are in the above from, you would set the line
number to 2 for the 2
nd
line, you would set the column number to 1 for the 1
st
character of
the 2
nd
line, and you would set the length to 12 to include all numbers in the phone
number (including the dashes).
NOTE: The format of ALI data changes from state to state and sometimes from county
to county. You will need to verify the format of your particular location. The DIR911t
assumes that the data is always formatted as 16 rows with 32 columns (carriage
return/new line are ignored in the character count).
Use the CURSOR soft key to select which parameter you wish to change. Use the
encoder to select the value. Use the ALL LINES soft key to apply the changes to all the
lines.
Configure ALI/ANI Serial Ports
The ALI/ANI serial port configuration screen is shown in Figure #32.
To Next Page
Loading...
