DIR911T User Guide
57
Current Security Level: HIGH
DONE
Figure 40: Security Level Screen
This screen is used to adjust the security level of the unit. There are two settings HIGH
and LOW. When the box is in the LOW security setting, entry into the system menus is
not password protected. When the box is in the HIGH security setting, entry into the
system is password protected.
Use the encoder to select the security level. Press the DONE soft key to effect the
changes.
Use the encoder to select the desired value. Use the CURSOR soft key to select which
field to update. Press the DONE soft key to effect the change and exit the menu.
Password Setup
The password setup screen is shown in Figure #41.
Please set your password:
0000
CURSOR INCREASE DECREASE DONE
Figure 41: Password Setup Screen
This screen is used to set the password for the unit. The password is used to control
access to the system setup screen when in high security mode.
Use the encoder knob to increase or decrease the value. Pressing the encoder knob will
move the cursor one location to the right. Use the CURSOR soft key to move the cursor
one position to the right. Press the DONE soft key to effect the changes.
To Next Page
Loading...
