210
EVINRUDE ICON REMOTE CONTROL SYSTEM
ICON REMOTE CONTROL SYSTEM FAULT MESSAGES
ICON Remote Control System Fault Messages
Note: ICON fault codes are grouped by fault type.
Fault Code:
Description
LED
Indicators
Possible Cause
Fault Description/
Troubleshooting Procedure
108:RPM Reduction,
ICON System Fail-
safe Mode
Fault code 108 will
appear with another
code that explains
why the engine(s)
entered RPM reduc-
tion.
See other codes See other codes See other codes
149: Throttle Actua-
tor Sensor Fault
(fault code 108 will
appear with this fault
code).
Throttle actuator sen-
sor cannot deter-
mine throttle position.
All LED indicators
flash until control
levers and shift actua-
tors are in NEUTRAL.
Afterwards, only the
NEUTRAL indicator
LED associated with
the engine that has a
fault flashes.
RFI due to excessive
spark plug gap, dam-
aged or worn spark
plugs.
Throttle actuator har-
ness is damaged.
Throttle actuator posi-
tion sensor is faulty.
ESM is faulty.
• Check spark plug condition.
Gap and install new spark
plugs.
• Check harness from ESM to
throttle actuator for damage.
• Swap a known good throttle
actuator.
• Swap a known good ESM.
150: Throttle Actua-
tor Motion Fault (no
other fault code
appears with this
fault code).
Throttle cannot move
toward open position.
FORWARD or
REVERSE indicator
LED flashes (depend-
ing on gear position
when fault occurred).
Throttle actuator has an
open circuit.
Throttle actuator is not
calibrated.
Throttle linkage is dam-
aged.
Throttle actuator is
faulty.
• Move control lever(s) to
NEUTRAL position.
• Turn master power/
key switch OFF and then
back to RUN position to
reset system.
• Check throttle actuator har-
ness for damage.
• Calibrate throttle actuator.
• Check throttle linkage for
obstructions
• Swap a known good throttle
actuator.
150: Throttle Actua-
tor Motion Fault (fault
code 108 will appear
with this fault code).
Throttle cannot move
toward closed posi-
tion.
All LED indicators
flash until control
levers and shift actua-
tors are in NEUTRAL.
Afterwards, only the
NEUTRAL indicator
LED associated with
the engine that has a
fault flashes.
To Next Page
Loading...
