Safety
2
Rivo™ I Controller EN
11
Evoqua Water Technologies GmbH | W3T597263 Issue 01-0624
2.1 Intended use
• The Rivo™ I Controller (Mod. E10) Electronics Mod-
ule must be used exclusively for the quantity-propor-
tional dosing of chemicals used, for example, in
municipal water treatment and similar industrial pro-
cess applications. The electronic module can control
actuators (e.g. V10K gas dosing system), dosing
pumps (Chem-Ad VPP) or analog actuators.
• The Rivo™ I Controller Electronics module may only
be operated in combination with actuators, dosing
pumps and analog actuators approved by Evoqua
Water Technologies GmbH.
• Operational safety can only be guaranteed if the
device is used in accordance with its intended pur-
pose.
• The device may only be used for the purpose defined
in the contract and under the installation, operating,
and environmental conditions specified in this instruc-
tion manual.
• No substances may be used other than those
described in this instruction manual (chemicals and
prescribed calibration chemicals).
• All inspection and maintenance work must be carried
out at the specified intervals.
• The system must be protected against access by
insufficiently qualified personnel by means of access
restriction and the assignment of passwords. Corre-
sponding security concepts must be provided to pre-
vent unauthorized remote access.
• All inspection and maintenance work must be carried
out at the specified intervals. Inspections and control
measures must be carried out at the prescribed inter-
vals and documented!
• Compliance with the intended use also includes read-
ing this instruction manual and observing all the
safety information, instructions and notes therein. The
owner/operator of the installation bears sole responsi-
bility for consequences of any use that does not con-
form with the installation’s intended use.
To Next Page
