2
Safety
EN Rivo™ I Controller
12
W3T597263 Issue 01-0624 | Evoqua Water Technologies GmbH
2.2 Improper use
• The Rivo™ I Controller (Mod. E10) Electronics Mod-
ule must not be used with actuators, dosing pumps
and analog actuators other than those recommended
and approved by Evoqua Water Technologies GmbH.
• Any use above and beyond the intended use.
• Use that deviates from the information in the technical
data.
• Modifications to the device or parts of the device.
• Assembly and installation of or work on electrical
components must be carried out by a qualified electri-
cian.
• The unit must not be operated with flammable liquids.
2.3 General safety instructions
The manufacturer places great emphasis on safety when
working on or with the device. This is already taken into
account in the design of the installation and by the integra-
tion of safety features.
Safety instructions
This instruction manual describes the safe and proper
handling of the device. The specified safety notes and
instructions, as well as the local accident prevention reg-
ulations and general safety regulations applicable to the
area of use, must be observed. Additional industry-wide
or in-house safety regulations also continue to apply. The
operating company is under obligation to provide operat-
ing instructions in accordance with local, national and
international specifications, regulations and legislation.
Modifications to the device other than those described in
this instruction manual are not permissible.
State-of-the-art technology
The unit has been constructed in accordance with state-
of-the-art technology and the accepted rules of safety
engineering. However, if the unit is used by persons who
have not been adequately instructed, danger to the life
and limb of such persons or third parties and damage to
the unit itself or to other property cannot be ruled out.
Work not described in this instruction manual must be per-
formed only by authorized personnel.
To Next Page
Loading...
