Evoqua Rivo I - Personnel Qualification

Safety
2
Rivo™ I Controller EN
13
Evoqua Water Technologies GmbH | W3T597263 Issue 01-0624
2.4 Personnel qualification
It is a prerequisite that all persons assigned to work on or
at the device are familiar with and comply with the work
safety and accident prevention regulations.
The operating company must train all persons handling
the system, device, components, substances etc. and
inform them of possible hazards.
It is the responsibility of the operating company to monitor
personnel qualification.
If the personnel do not have the necessary knowledge,
they must be trained. The responsibilities for work on and
with the device (assembly, installation, installation or de-
installation of interfaces, operation, troubleshooting, start-
up, shut-down, maintenance, dismantling as well as stor-
age, transport and disposal) must be clearly defined and
adhered to so that there is no unclear distribution of com-
petencies from the point of view of safety.
Only persons who can be expected to perform their work
reliably may work on and with the device. Refrain from any
working method that affects the safety of persons, the
environment or the device.
Persons who are under the influence of drugs, alcohol or
medication affecting their ability to react must not work on
or with the device. When selecting personnel, the age-
and occupation-specific regulations applicable at the
device's place of use must be observed.
The operator must ensure that unauthorized persons are
kept at a safe distance from the device.
Personnel are under obligation to immediately report to
the operating company any changes that occur in the
device that affect safety.
WARNING
Danger from unqualified personnel
Possible consequence: fatal or serious injury and signif-
icant material damage.
• The company operating the overall system must
ensure that only authorized and qualified personnel
are permitted to work with and on the device and
within their defined scope of authority.
• Unqualified personnel must be kept away from the
device.
• The system must be protected against access by
insufficiently qualified personnel by means of the
assignment of passwords and access restriction.
• Work on electrical components must be carried out
by qualified electricians.