1
General notes
EN Rivo™ I Controller
4
W3T597263 Issue 01-0624 | Evoqua Water Technologies GmbH
1 GENERAL NOTES
1.1 General precept of non-discrimination
In the interest of better legibility, the linguistic forms male,
female and diverse (m/f/d) are not used in parallel in this
instruction manual. Nevertheless, all personal nouns and
pronouns are understood to apply equally to all genders.
We apologize for any inconvenience this may cause.
1.2 Target groups
Only trained and authorized specialist personnel are per-
mitted to work on the Rivo™ I Controller (Mod. E10) Elec-
tronics Module. All electrical work (e.g. electrical
installation, installation of Rivo™ Flex Modules) must be
performed by a qualified electrician. The sections on
assembly, installation, start-up, system messages, faults,
maintenance, shut-down and dismantling are intended
exclusively for trained specialist personnel. Operation,
storage, transport and disposal can be carried out by
instructed personnel.
1.3 Information in the instruction manual
For clarity, the Rivo™ I Controller (Mod. E10) Electronics
Module is referred to in this instruction manual as the elec-
tronic module or the device.
Details of the actual equipment may differ from those
shown in the illustrations.
WARNING
Danger in the case of failure to observe the instruc-
tion manuals
Possible consequence: fatal or serious injury and signif-
icant material damage.
• All persons working with the Rivo™ I Controller
(Mod. E10) Electronics Module must have read and
understood these instruction manual and the associ-
ated manuals.
• The warnings and safety instructions must be
observed.
• The owner/operator is responsible for ensuring com-
pliance with the relevant accident prevention regula-
tions, other statutory provisions and the accepted
rules of safety engineering.
To Next Page
Loading...
