EVS LSM-VIA

Limitations
• If the playlist is in Playout mode, it is not possible to insert a clip in it.
How to Insert a Clip in the Loaded Playlist
By default, playlist elements are inserted before the active element in the playlist.
This setting can be changed from the LSM-VIA configuration tool.
1. Load a playlist.
See section "Loading a Playlist" on page 218.
2. Browse to a playlist element before, or after, which you want to insert a clip.
3. Load the clip to be added to the playlist.
The clip is loaded on the PRVchannel.
4. Insert the loaded clip at the selected position in the loaded playlist in one of the following ways:
◦ +
◦ from the left operational block.
The inserted clip becomes the active element in the playlist.
In Clip mode, you can also insert the loaded clip in the active playlist before or after the active
element by using the Insert function.
Adding Clips to the Active Playlist from the Viewer
How to Add Clips to the Active Playlist from the Viewer Clip Grid
1. Select
◦ the Clip view to add all the angles of a clip: or
or
◦ the CAMview to add individual CAMangle(s): or .
USER MANUAL
LSM-VIA |7. Working with Playlists| 155