S2000 Elite - User's Guide
035-00707 Revision 1
18
Figure 3: Lamp Orientation
1. Spring Clamp
2. Center Position
3. Right Power Lead
1. Locate the 6-pin Intelli-Lamp sensor connector at the rear of the lamp module and
connect it to its mate located on the top of the lamp-housing wall.
2. Tuck the Intelli-Lamp cables into the grommet shown in Figure 4 or else it may obstruct
the panel door from closing.
The Intelli-lamp connector will only attach in the correct orientation. If there are
difficulties attaching the connector, try rotating it by 180º.
If the Intelli-lamp connector is not installed correctly, the lamp will not strike and the
screen will display a Lamp Strike Error when POWER is turned on to the unit.
To Next Page
Loading...