Dante Controller Configuration
Now that the DMP128ATs are configured for network operation and the Dante software
is installed, Dante Controller must be configured.
Start Dante Controller
To launch Dante Controller.
From the DSP Configurator menu bar, select Tools>Network Audio Control.
Figure 72. Network Audio Control
Dante Controller launches. If the network has a DHCP server, it receives its IP
configuration using the standard DHCP protocol. On a network without a DHCP server, a
Dante-enabled device automatically assigns itself an address using link local protocols.
Once connected, Dante Controller begins to auto-discover other Dante devices. While
scanning the network, it also advertises itself to allow other Dante-enabled devices to see
and communicate with it.
DMP128 • Software Control 118
To Next Page
Loading...
