Extron electronics DMP 128 User Manual

DSP Configurator Program Basics
Starting the Program
NOTE: Extron recommends connection via the Ethernet LAN port for running the
DSPConfigurator program.
To run the DSP Configurator Program, click
Start > Programs > Extron Electronics > DSP Configurator > DSP
Configurator.
DSP Configurator starts in Emulate mode (see figure 13, next page). Also see Emulate
Mode and Live Mode on page89.
Using the Program
In the DSP Configurator Emulate mode, audio parameters can be selected, then
transferred to the DMP128 by switching to Live mode (while connected to a DMP128)
and pushing the configuration. Audio settings can also be tailored while connected to the
DMP128 for real-time auditioning of the audio output as adjustments are made
(see Emulate Mode and Live Mode on page89).
The main screen contains controls for the input and output channels, virtual sends and
returns, expansion outputs and inputs, and other information used in the operation of the
DMP128. There is too much information contained on the main screen to enable viewing
of the entire mix board at one time, so several methods, outlined on the following pages,
are provided to scroll through the screen.
DMP128 • Software Control 16

Extron electronics DMP 128 Specifications

General

Brand	Extron electronics
Model	DMP 128
Category	Processor
Language	English