DSP Configurator Toolbar Menus
The DSP Configurator contains the following menu bar, arranged horizontally below the
title bar:
• File • Edit • View • Tools • Window • Help
File
NOTE: New, Open, and Recent Files are unavailable in
Live mode.
• New — Discards the current DSP configuration (after
prompting to save changes) and opens a blank
configuration file.
• Open — Loads and activates a previously saved DSP
configuration file.
• Save — Saves all changes to the current DSP configuration
file under the current file name. If the file has not previously
been saved, prompts for a file name.
• Save As — Saves all changes to the current DSP configuration file under a new file
name.
• Backup — Recalls and transfers all partial presets plus the current configuration to a
DSP configuration file within the DSP Configurator program.
• Recent Files — Opens a list of recently opened or saved DSP configuration files.
• Exit — Closes the DSP Configurator Program.
Edit
• Cut — Remove all parameters of a selected
processor block or set of selected blocks to the
clipboard. If not followed by a Paste command to a
different block, the parameters are restored.
NOTE: Processor blocks are not removed from the processor stream after a
Cut and a subsequent Paste operation. Only the parameters are moved.
Processor blocks and their parameters can be pasted only into another
block of the same type. For example, the input 1 filter block and all of its
parameters can be copied to the input 2 filter block but not to the input 1
delay block.
• Copy — Copies all parameters of a selected processor block, gain block, or set of
selected blocks to the clipboard.
• Paste — Inserts processor blocks and their parameters from the clipboard into the
the location selected.
DMP128 • Software Control 21
To Next Page
Loading...
Need help?
General
