Tools
The Tools menu (see right) contains these selections:
• Clear All Groups — clears all
group members and group master
parameters. Soft limits are also
cleared.
• Increment/Decrement
Simulator — allows the user to
test increment/decrement values (see
below for more information)
• Refresh All Group Data —
Updates group members and group master parameters.
• Group Details Report — generates a report, listing all group masters and membership
(see Group Details Report on page87).
Increment/Decrement Simulator
The Increment/Decrement Simulator provides a control for increment and decrement, with the
ability to set increment and decrement values. The control is temporary, since the value is not
remembered in the device.
To use the Increment/Decrement Simulator:
1. Select Tools > Increment/Decrement Simulator.
2. Select the group to be controlled from the Select Group drop-down list. The following
dialog box opens:
Figure 55. Increment/Decrement Simulator Dialog Box
NOTE: The Number of Group Members: readout indicates the number of
controls affected.
3. Enter an increment value and a decrement value. The default value is 1.
NOTE: The size of the increment can be changed by typing a value in the
Increment Value or Decrement Value field. Values can be as large as
the maximum range of the control or as fine as 0.1dB. For groups controlling
mute, 1 is the only valid value.
4. Click Increment and Decrement as needed. The group master control increases or
decreases by the set value to the top or bottom of its soft limit range.
NOTE: When set, soft limits cannot be exceeded.
DMP128 • Software Control 86
To Next Page
Loading...
Need help?
General
