IN1608 xi Scaling Presentation Switcher • Internal Web Pages 110
To adjust the program volume:
1. Click the Mix Controls tab (see figure 68,
1
, on page 108).
2. Adjust the level using any of the following methods (
6
):
• Click and drag the fader handle to the desired level.
• Click in the level text field below the fader and enter a new value. Then, press the
<Enter> or <Tab> key to apply the change.
• Click the Up or Down arrow button to the right of the level text field to respectively
increase or decrease the level in 0.1 dB increments.
3. If desired for the Program Volume fader, click and drag the minimum and maximum soft
limits to define new minimum and maximum values within the original range.
4. To mute the program volume, click the Mute button (
7
) below the Program Volume
fader.
To adjust individual output gain:
1. Click the Program Volume Offsets button. The Program Offsets panel appears
below the Group Controls panel.
NOTE: If the Program Volume Offsets button is not visible on the screen, slide the
cursor to the right of the heading above the Program Volume fader, until the cursor
becomes a “hand” icon and a Program Offsets text box pops up.
Click where the cursor is currently positioned (see
1
in the illustration above) to
display the Program Assets panel.
2. Adjust the level of each desired output by any of the following methods:
Figure 69. Program Offsets Panel
• Click and drag the fader handle to the desired level.
• Click in the level text field below the fader and enter a new value. Then, press the
<Enter> or <Tab> key to apply the change.
• Click the Up or Down arrow button to the right of the level text field to increase or
decrease the level in 0.1 dB increments.
To Next Page
Loading...