Extron electronics IN1608 xi IPCP SA with LinkLicense - Page 66

IN1608 xi Scaling Presentation Switcher • SIS Configuration and Control 58
Command ASCII Command
(Host to scaler)
Response
(Scaler to host)
Additional Description
Input Configuration Commands (continued)
Auto-Image
Enable
X!
*1A Img
X!
*1
]
Activate Auto-Image for input
X!
.
Disable
X!
*0A Img
X!
*0
]
Turn off Auto-Image for input
X!
.
View
X!
A
X(]
In verbose modes 2 and 3:
Img
X!
*
X(]
View the Auto-Image setting for
input
X!
.
Execute
A
Img0
]
Execute an Auto-Image for the
current input (follows the aspect
ratio of the current input).
Execute and fill
1*A
Img1
]
Execute an Auto-Image and fill the
entire output.
Execute and follow
2*A
Img2
]
Execute an Auto-Image and
maintain the aspect ratio of the
current input.
Auto-Image threshold value (luminosity value which the scaler defines as active video for Auto-Image)
Set value
EX3)
ALVL
}
Alvl
X3)]
Set the global Auto-Image luminosity
to
X3)
.
View
E
ALVL
} X3)]
In verbose modes 2 and 3:
Alvl
X3)]
View the global Auto-Image
luminosity setting.
Horizontal start
Specify a value
EX$
HSRT
}
Hsrt
X!
*
X$]
Set the horizontal start position.
Increment value
E
+HSRT
}
Hsrt
X!
*
X$]
Shift the horizontal start position to
the right by one pixel.
Decrement value
E
-HSRT
}
Hsrt
X!
*
X$]
Shift the horizontal start position to
the left by one pixel.
View
E
HSRT
} X$]
In verbose modes 2 and 3:
Hsrt
X!
*
X$]
View horizontal start position
X$
for
the selected input (
X!
).
Vertical start
Specify a value
EX$
VSRT
}
Vsrt
X!
*
X$]
Set the vertical start position.
Increment value
E
+VSRT
}
Vsrt
X!
*
X$]
Shift the vertical start position up by
one line.
Decrement value
E
-VSRT
}
Vsrt
X!
*
X$]
Shift the vertical start position down
by one line.
View
E
VSRT
} X$]
In verbose modes 2 and 3:
Vsrt
X!
*
X$]
View vertical start position
X$
for the
selected input (
X!
).
NOTES:
X!
= Input selection
1-8
X$
= Horizontal and vertical start
0-255 (128 = default)
X(
= Auto-Image On or Off status
0 = off or disabled, 1 = on or enabled
X3)
= Auto-Image threshold value
0-100 (where 0 = black and 100 = white; 25 = default)