Fairlight Xynergi - Fader Sets

User Manual THE NUMPAD February 16, 2010
Xynergi Media Production Centre Page 103
Step 3 While Set is latched, you may store other timecodes by pressing the 1, 2 or 3 button
Step 4 Press the
Set button to unlatch it
To retrieve (locate to) the timecode stored in a location (momentary mode):
Step 1 Hold down the
Loc button
Step 2 Press the
1, 2 or 3 button
Step 3 Release the
Loc button
The same thing in latched mode:
Step 1 Press the
Loc button
Step 2 Press the
1, 2 or 3 button
Step 3 While
Loc is latched, you may locate to any stored timecode by pressing the 1, 2 or 3
button
Step 4 Press the
Set button to unlatch it
Notes: Before you Set a timecode into a Location, its value is zero (and can be used to locate
there)
The stored timecodes include only whole frames, so you can only use them to locate to frame
edges. This makes them inappropriate for holding fine edit points. For these you should use Marks
(see Using Marks in the How To Chapter, Basics section).
Fader Sets
When used with external faders (Fairlight Xe6, Sidecar or Mackie fader blocks) it allows different
combinations of channels to have their faders mapped to the control surface.
To activate a fader set (momentary mode):
Step 1 Hold down the
Fader Sets button
Step 2 Press a button from
1 to 9
Step 3 Release the
Fader Sets button
The same thing in latched mode:
Step 1 Press the
Fader Sets button
Step 2 Press a button from
1 to 9
Step 3 While
Fader Sets is latched, you may choose any fader set by pressing a button from 1
to
9
Step 4 If desired, press the
Fader Sets button to unlatch it – if you prefer, you can keep the
Fader Sets layout handy for more changes.
Mixer Set
Mixer Set is an option that takes over some of your faders and automatically places selected
channels on them. As you select and de-select channels, they dynamically come and go from the
faders. This makes it very easy to mix a large number of channels with a small number of faders.