User Manual USING XE-6 FADERS February 16, 2010
Xynergi Media Production Centre Page 225
Note: Simply pressing and releasing the Pot button toggles between the standard function (Pan L-R)
and the most recent non-standard function that you used. If you have not used any non-standard
function, it toggles between Pane L-R and Pan F-B (front / back).
Fader Function
The standard fader function is to control the send level of the channel to its assigned buses i.e Main Bus
and sub-busses.
Faders can also control a number of other parameters. To change the function of the faders:
Step 1 Select the
Mixer Megamode on the Xynergi surface
Step 2 Press the
Faders To… button.
Step 3 Select from the available functions that appear on the Xynergi buttons
Step 4 Press the
exit button.
The OLED display names the function you are controlling with the fader. Note that the
Mute button
always “follows” the fader function – if that is possible. For example, if the fader is controlling the send
level to Aux 1, the
Mute button cuts that send. But if the Fader is controlling Record Level for the track,
the
Mute button has no function.
To Next Page
Loading...