User Manual HOW TO … February 16, 2010
Xynergi Media Production Centre Page 51
Punch Individual Tracks
Put the transport into record by pressing Play and Record together. Nothing is recording yet,
because nothing is armed.
Now press one of the
track keys of the patched tracks. That track will go into record.
Press another track key. The second track will go into record. Press it again – it comes out of
record, while the first track continues to record.
Auto Rec
Overview
Constellation allows you to record sections of track automatically, with the transport doing the
pre-roll, punch in and punch out.
This is done by making a range, using the From and To keys, then using the Record Range
command on the Record menu.
Get Ready
Press the green Record Megamode button to access recording functions.
Patch inputs to a one or more tracks, and arm them (see How to Recording Patch Inputs
for details).
Auto-Rec uses a Pre-Roll. The Pre-Roll time can be set in the ADR menu (press the green
Record
Megamode
button then ADR, then use the on-screen dialog).
Auto Rec Operation
Make a range as follows:
Locate to the desired in point and press the
From key.
Locate to the desired out point and press the
To key.
The
rec range button is displayed to the left of the Jog Wheel.
Press the
rec range button to do an automatic recording of the range.
Patching Signal Paths
Overview
The previous topic mentioned patching inputs to tracks. This section deals with the subject in
more detail.
Before a track can be armed, it must have some type of input signal, or source. Normally this will
come from a Physical Input (analog or digital). It may also be a Bus Output, the system Oscillator,
the Direct Output of another signal path, an Insert Send, and so on.
Patching (connecting) any of these signals to the input of a track (or to some other destination) is
done on the Patch dialog. This is accessed from the Record, Mixer or Setup Megamodes. To get
there, press one of the green buttons with these labels.
The Patch Dialog
Press the Patch button to display the Patch dialog.
To Next Page
Loading...