User Manual HOW TO … February 16, 2010
Xynergi Media Production Centre Page 84
Hold the last value you wrote is held until the end of the Project, erasing all following changes.
Event the last value is held until the next event i.e. change in value that you wrote previously,
using the Glide Out Time (see Utils menu).
Set the value you want.
Working With the Pad
Select signal path(s). Turn MULTI on if you want to change values on all the selected paths
simultaneously.
Press the
Write-Trim button until Write is selected.
Press
Play and then AUTO (or vice versa). The Level and Pan backgrounds go red and begin
writing values.
Move knobs, then press
Stop. Enabled controls go into read.
Press
Play Menu twice to review what you have just written.
Press the
Undo Pass soft key to remove the new automation data. Note: there is only one level of
undo.
Fader Control
Overview
The steps in working with faders are similar to working with the Pad, except that enabling the
path is done locally, on the fader itself.
This procedure applies to Fairlight sidecars, but not to Mackie faders.
Mix On must be lit (in the Mixer Megamode)
Select On Stop setting.
Enable at least one mix parameter (fader, mute, EQ etc)
Write or Trim can be selected with external faders.
Put each fader into Write using its own Auto button.
Operation
Perform the following from the previous section:
Enable Parameters
On Stop setting
Choose Write or Trim.
Press Play and then the Auto button on any fader (or vice versa). Fader knobs go red on the
Mixer screen. Level and Pan values begin writing.
Move controls, then press
Stop. Enabled controls go into read.
Press
Play Menu twice to review what you have just written.
Press the
Undo Pass soft key to remove the new automation data. Note: there is only one level of
undo.
To Next Page
Loading...