User Manual HOW TO … February 16, 2010
Xynergi Media Production Centre Page 90
Get Ready
Press the green Mixer button.
Press the
mix menu button.
Press the
mix ON button so that it is illuminated.
Details
Enable a path by selecting it.
Press
enable params and select faders and pans. Press exit
Locate to the desired IN point and press
From.
Locate to the desired OUT point and press
To.
Press Preview to toggle it on. The preview button pulses. The AUTO button on Xynergi or on a
Fairlight Sidecar will now put its corresponding path into Preview mode.
Press
AUTO. The Level and Pan backgrounds go yellow.
Change the static values of Level and Pan as desired.
Press the
fill range soft key.
Note:
Write / Trim has no effect. Values are always written by fill range.
Isolate
Overview
Isolate is a way of disconnecting the automation from selected signal paths.
When a path is isolated, all its controls are manually operated, and no automation data can be
written for them.
Get Ready
Press the green Mixer button.
Press the
mix ON button so that it is illuminated.
Operation
Pressing isol brings the SEL display to the screen.
Any path you select will be isolated from the Automation system.
You may need to select
Tracks, Lives or Buses first, then press the path buttons that you want
to isolate.
Press
exit to return to the Mix menu
Auto Safe
Overview
Auto Safe prevents signal paths from entering Write or Trim.
Safe paths still Read their automation data, if any exists.
To Next Page
Loading...