User Manual HOW TO … February 16, 2010
Xynergi Media Production Centre Page 98
Locate the transport so that the cursor crosses the middle of (at least) one clip. Identify the track
containing that clip, and double-press its button to make it the only selected track. (If necessary,
use the
Bank key.)
Press and release
trim head. The head of the clip is trimmed back to the cursor location. Jog
back a bit and press
Enter. The head is extended to the new position.
This time, press and hold
trim head. The system exposes the whole head of the original
recording. While holding down
trim head, Jog over the exposed audio and choose where to trim
it. Release
trim head when ready. The clip is trimmed to your current position.
Slipping clips
Overview
Slipping clips is an alternative to Cut and Paste (see How to Editing Cut n Paste). It has the
advantage of leaving the clipboard undisturbed, but does not allow moving clips to other tracks.
We can also
slip the sync of a clip. This means that the clip stays in the same place, but the
audio inside the clip slips earlier or later. This means exposing a different portion of the original
recording.
Note: another quick way to slip a clip is to drag and drop it with the mouse. You can drag it to
another track as well. Holding down the SHIFT key holds sync while you drag to another track.
Get Ready
Press the green Editor button.
Operation
Press the trim / slip button. If the word trim is highlighted, press it again so that slip is
highlighted.
Locate the transport so that the cursor crosses the middle of (at least) one clip. Identify the track
containing that clip, and double-press its button to make it the only selected track. (If necessary,
use the
Bank key.)
Press
slip clip. Jog forward by about one second and press Enter. The clip moves by the
distance you jogged. Jog some more and press
Enter again. You can keep doing this.
This time, press and hold
slip clip. Keep holding it down, Jog forward, then release. This is a
faster way of doing the same thing.
Press the
Sync Point soft key. Now, when you Jog and press Enter, the audio inside the clip is
slipped.
Track Selection
Overview
Most editing operations work on multiple tracks at the same time.
All the red clips or parts of clips are affected.
This guide will show you how to select tracks.
Get Ready
Press the green Editor button.
To Next Page
Loading...