Fayat DYNAPAC CT3000 - Page 28

Emergency Procedures
24 4812325559EN 2018-02-20
3. In the fuses and relay compartment, disconnect the cable
312 (X.10 connector) and connect cable 312 (X.10GT
connector)
4. In the transmission module, disconnect the XA9.R1
connector
NOTE: The procedure above neutralizes the transmissions
normal operation and enables the emergency mode.
5. In the cab activate the button in the panel
NOTE: The emergency mode reduces functionalities of the transmission,
it only allows that the machine to work on the 1º gear (forward or
backward).
5
Fig 4 – Connector XA9.R1
Fig 5 – Forward/Backward button
Fig 3 – Cable º312
3