Fayat DYNAPAC CT3000 - Maintenance - Maintenance and Lubrication Procedures Lubrication and Maintenance Procedures; Default Chapter; Lubrication and Maintenance Procedures

Maintenance – Maintenance and lubrication procedures
56 4812325559EN 2018-02-20
Lubrication and maintenance procedures
Maintenance and lubrication procedures should be made based
on the number of operation hours, than subsequently based on
the periods, as daily, weekly, etc.
Always clean around the caps, grease trays or plugs
before opening or applying grease.
Observe and follow the engine manufacturer
instructions. For further information, refer to the
Engine Manual.
DAILY (Every 10 hours of operation)
ITEM ON
PAG. 52
PROCEDURE
PAGE
Before starting the engine
18 - 21
Check the brakes
58
12
Check the scrapers adjustment
59
9
Check the tire pressure
60
17
Check the tightening of the wheel bolts
60
5
Check the hydraulic oil reservoir oil level
61
22
Check the alignment of the cab cushions
61
1
Check the engine's coolant level
62
14
Check the engine's lubricant oil level
62
2
Check the tension on the alternator's belt
63
3
Check the pre-filter's water divider
63
20
Check the transmission box oil level
64
-
Check the Multi-function display and the operator's
control keyboard
64
At the end of the work shift
11
Refuel the fuel tank
65
22
Check the cabin's cushion height
65
28
Check the exhaust gases post-treatment connecting
line (Tier IV Engine)
66
4
Clean the dust ejector valve (Tier IV Engine)
66