Fayat DYNAPAC CT3000 - Item on; Pag. 52; Procedure Page

Maintenance – Maintenance and lubrication procedures
2018-02-20 4812325559EN 57
WEEKLY (Every 50 hours of operation)
ITEM ON
PAG. 52
PROCEDURE
PAGE
9
Check the tire pressure
67
17
Check the tightening of the wheel bolts
67
8
Check batteries
68
7
Lubricate the chassis joint
69
-
Lubricate the steering system joints
69
27
Lubricate the longitudinal transmission shaft (axle
shaft)
70
-
Check the condition of the hydraulic hoses and
connections
70
4
Clean the main and the air filter safety element
70
6
Replace the hydraulic oil filters
(ONLY ON THE FIRST 50 HOURS)
71
After the first 50 hours of operation, replace the
engine oil, the hydraulic system filter elements, the
fuel filters, the engine lubricant oil;
Do NOT replace the hydraulic oil now.
In more severe temperature environments and dust,
reduce the frequency of cleaning the radiator.
BIWEEKLY (Every 100 hours of operation)
ITEM ON
PAG. 52
PROCEDURE
PAGE
16
Replace the front and rear axle oil (ONLY ON THE
FIRST 100 HOURS)
72
19
Replace the oil filters of the transmission box (ONLY
ON THE FIRST 100 HOURS)
72
7
Verify the torque in the screws of Chassis joint
72
Only the initial replacement. The other ones should
be done every 1,000 hours.