Fayat DYNAPAC CT3000 - Check the Exhaust Gases Post-Treatment Connecting; Clean the Dust Ejector Valve (Tier IV Engine); Line (Tier IV Engine)

Maintenance – Daily (Every 10 hours of operation)
2018-02-20 4812325559EN 69
Check the exhaust gases post-treatment
connecting line (Tier IV Engine)
Check leakages, cracking and loose connections in an exhaust
line.
Check all the line connections, from the turbocharger up to the
exhaust line. Be careful with the connecting lines of the Diesel
Particulate Filter (DPF), and tight the clamps, if necessary.
For further information, refer to the Operation and
Engine Maintenance Manual.
Check if there is damage and dirt in the exhaust gases post-
treatment connecting line system. Clean it, if necessary.
Clean the dust ejector valve (Tier IV Engine)
Clean the dust ejector valve from the air filter daily, after the
working shift, pressing the valve and releasing the dust when it
is open.
When there is no dust remaining in the valve, release it.
For further information, refer to the Operation and
Engine Maintenance Manual.
Fig. – DPF
Fig. – Dust ejector valve