Fayat DYNAPAC CT3000 - Special Instructions

Maintenance – Special instructions
2018-02-20 4812325559EN 95
Special instructions
Recommended
standard fluids and
oil
When the machine leaves the factory, it is fueled with
the recommended fluids and oils indicated in the item
“Symbols and lubricants”, which are the proper ones
for operating in environments with temperatures
between 14 °F (-10 °C) - + 104 °F (40 °C).
The following recommendations are only applied for
operations under temperatures up to + 122 °F (50 °C).
Maximum room
temperature: + 122 °F
(50 °C)
The engine can operate up to this temperature using
the standard operating oil, but for other components,
use fluids with SAE 20W specification.
High pressure
washing
It is important to verify if the water jet under
pressure is not hitting the fuel tank and
hydraulic system caps.
Cover the filler nozzle caps with plastic and secure it
with rubber bands. This procedure prevents the water
to penetrate in the cap breath hole, which may cause
issues in the involved systems and possible clogging
in the filters.
NEVER drive the water jet under pressure into
electrical or electronic components, or into the
instrument panel (always keep them covered with
caps or plastic wrappers).
Fire extinguishers
In case of fire on the equipment, use the carbon
powder or carbon dioxide class ABC fire extinguisher.
Roll Over Protective
Structure
(ROPS)
NEVER perform welding or make holes on the ROPS
structure.
NEVER repair a ROPS structure; replace it for a new
one.
Auxiliary starter
While using an auxiliary battery in parallel with the
ones installed on the roller, always connect the
positive (+) terminal of the auxiliary battery to the
positive (+) terminal of the installed battery, and the
negative (-) terminal of the auxiliary battery to the
negative (-) terminal installed on the roller.
Welding on the
structure
To perform any welding work on the machine,
proceed as follows:
- Turn off the main switch;
- Remove the connectors from all the electronic
modules or remove the grounded cables from the
machine (3 on chassis and 2 on the cab).
For further information, refer to the chapter "Welding
on the structure".
Welding on the Structure