Fayat DYNAPAC CT3000 - Check the Hydraulic Oil Reservoir Oil Level; Check the Alignment of the Cab Cushions

Maintenance – Daily (Every 10 hours of operation)
64 4812325559EN 2018-02-20
Check the hydraulic oil reservoir oil level
1. Park the machine in a leveled ground and shut off the engine.
2. Check the hydraulic oil reservoir (1) located on the left side
of the machine, behind the operator's post.
3. If the oil level is 2 cm below the upper line of the display, fill
with the recommended hydraulic oil.
Use only hydraulic oil recommended by DYNAPAC.
Check the alignment of the cab cushions
1. Park the machine on a completely flat surface, shut off the
engine and the main switch.
2. Check if the arrow in the scales is aligned with the number
ZERO, in the four cushions.
NOTE: The adjustment is at real time, or in others words, when
a cushion is inflated of deflated, the other cushions are affected
as well.
3. Apply compressed air in the valves or deflate the cushions
crossed, according to the scale, starting from the front right
side, then going to the rear left side, posteriorly, to rear right
side and finally finishing the checking on the front left side.
NOTE: A compressor with a capacity of 50 psi is enough for the
job.
1
Fig. – Hydraulic oil reservoir
Fig. – Alignment scale